Third-Party Dimensional Control

Anko has extensive experience with third-party dimensional control and performs assignments worldwide. With our equipment and expertise, we conduct thorough assessments of the work done and report deviations that necessitate correction of any discrepancies and deficiencies.

We can carry out measurements for even the most demanding constructions and have equipment that can be used with very strict tolerance requirements.

An example of this could be the assembly flanges on wind turbines where the tolerance for flatness of the flange is often set to 0.2 mm.

We then use equipment that has a measurement accuracy of 0.01 mm.

We are Quickly on Site in Acute Cases

Should an acute situation arise, you can count on us to be on the case! We quickly mobilize to survey any errors that have been made or if damage has occurred to already approved constructions right before installation.